> i've done fence work and usually set the post in concrete, only we would >make sure to "mound" the crete on top around the post so the water would'nt > ...
Best option is to attach a treated wooden post & fix the gate to that. Go for the centre & you should miss the rebar. I use Multi Monti's or Thunderbolts - ...
Anyone used a fence sprayer on a fence that has concrete posts and concrete base panels? If so, how do you keep the preserver off the posts and panels?
You'd need to make a sort of wooden mould around the post an then pour it in. it's quite runny so it would spread into the cracks a bit. http://www.netweber.co.
So you have twisted > posts. Metpost repair spurs slide neatly between the post stump and the concrete - it would be quite hard to put them in crooked.
We're using redwood tree trunks that we will sink in post holes with concrete for fence posts. My question is, should we scrap the bark off or does the bark ...
Do I need to take any special precautions when drilling and plugging the concrete posts? Peter. David W.E. Roberts's profile photo. David W.E. Roberts. unread ...
It would be nice to have the posts and panels the same colour. Has anyone used fence paint on concrete posts with good results? We have used Cuprinol Garden ...
slightly so they get narrower at the bottom? Also, I will probably use a post fix concrete ... concrete fencing they put on one of the small "off" ramps there.
May 5, 2009 ... > fences before and instead of concreting in the fence posts I have used > ... I use wooden posts supported by concrete blocks or slabs or ...
I received a bid for a cedar mod panel fence for about $23 per foot with posts set in concrete. For 10% more, they would put a metal pipe inside the posts ...
should be below ground. If the post is four foot above ground, that would mean you may need to dig out 24 inches of post. Then you need to figure out how to ...
Mar 8, 2006 ... ... posts so these metal poles are no longer eyesores, but to then use this wrapped posts to build a normal wood panel fence. Do you think using ...
Jun 11, 2013 ... To ascertain the thickness of the concrete, you could do this in 2 ways. ... >>>> I need to erect a short paneled fence across an area of concrete ...
May 22, 2021 ... ... use of poles/fence posts and plates do a wonderful job for that. ... you need to use concrete mix to repair. The limit on size is your ...
I will be putting some fence posts up over the weekend and I have just noticed the use by date on my cemet was the start of this month. Can I still use it?
>> You don't usually need concrete at all for fence posts. If the hole ... above. When we did the fence here with concrete posts a few years back the sandy
>squeezing out at the sides). > When I did my last shed, I put down some concrete blocks (actually, I ... and then laid the bearers (treated fence posts) across ...