I have a Kenmore H3 washer. During the last 4-5 minutes of the spin cycle (moving fast), it starts shaking and making a racket. At first I thought it was an ...

... the washer would last much longer than other machines. ... We noticed that the problem usually occurred during the first rinse cycle or late in the last wash ...

doesn't come back on once it goes off but the washing cycle just carries on. ... Often on hot washes the > program waits in a holding state until the ...

ago. Last night the machine appeared to get confused. It took a very long ... Wash cycle is selected as normal. Drum appears to fill as normal, consume ...

Nov 26, 2016 ... After a closer inspection of the shaft, I found a thin metal washer and a small rubber ring at the bottom of the shaft. I can't tell if they are ...

So, my cloths get clean enough in my washer Whirlpool duet with the great sanitize cycle. I have noticed that they get cleanest in a small load of just the ...

Sep 2, 2016 ... So tonight I started disassembling the washer to do just that, but then when I came to take the motrr off I noticed black soot on the center ...

the hose and then put the clothes in the washing machine with a normal ... rinse cycles usually does the trick. The sit harnesses can go the same way ...

The springs or shocks at the top may be fine but you would have to take off the back and check the bottom ones. If they look to be ok, then I would then check ...

Here's a LG WM2301HW on normal/cotton cycle, it runs too long to fit in one spectrogram. Notice in the second plot around 23:41 UTC between 18 and 25 Hz, I ...

I unplugged the washer for a few minutes, plugged it back in and restarted the cycle. ... do a rinse cycle with no clothes in the washing machine. Even ...

Then I dried the laundry on an either normal cycle or sanitize cycle in my Whirlpool dryer. After the dryer, I blotted 10 more pieces of the clean, dry ...

I simply put them in the machine on top of the clothes and ran a normal cold wash cycle. ... to the last 2 wash cycles in the detergent dispenser. (The ...

>should before it manages to stop the fill. This may explain why the problem >occurs only on long wash cycles. Short washes often use less water to begin

When my washing machine goes to the drain cycle and starts spitting all the ... Usually have to do this once or twice. Once the first couple of seconds ...

This is my experience repairing the Maytag Washer Atlantis Mav Series 9750 Aww, I had to replace the spin bearing since it was making a jet engine noise when ...

Oct 6, 2014 ... now that I think about it, 30-60 minutes would be a better repeat cycle. ... Is it safe to assume that the wash cycle is always the same duration?

However, the combination of the hot sanitize cycle, bleach, washing away the germs, and the hot dryer is the best we can do and usually keeps the germs from ...

In the art, a wash cycle typically comprises 3 principal stages: a main wash, an intermediate rinse, and a final rinse. An optional pre-wash stage may precede ...

... washing machine appliance 100 since the wash count was last reset. In the embodiment of FIG. 3 , if it is determined that the previously executed cycle was ...