Jitensha Studio did the job and those folks don't hack. I don't think I'd go so far as to use zip ties to install Honjo fenders. Wouldn' ...

Of all the clamps, the SQR holds bags highest -- necessary to carry a bag when there is little distance between tire ... zip ties, when I put that bag on it for ...

The Soma rack has zip tie mounting holes. It's been my experience that it's the sliding around that causes zip ties to fail. Of course I usually just put on a ...

I ground some small notches into the right vertical support to hold zip-ties in place for securing the trailer wiring. ... The first time I put weight on the bike ...

Jun 10, 2010 ... stopping more of the splash when hitting puddles. Inside mounting follows the tire radius, reducing the trajectory of a ... I zip-tie the leather ...

Fitting Your Bike · Fuel / Fuel ... Tuck the offending hose up under the tank so it does not hang down - use zip tie to the upper frame to hold it there.

some zip-ties may do the job. If you use zip-ties, get the best quality ones ... convenient mudguard mounting point for touring bikes. You'd likely do

... zip tie or wire, hang it from the rear peg. Do not disconnect the brake line. 4) Remove the brake caliper bracket mounting bolt. 5) Loosen the large rear ...

I do have to remember to install one of your fender reinforcement plates at the chainstay bridge next time I have the bike in the stand, rear wheel out, and ...

Unhook everything and cut any zip ties holing them together (remember to re zip tie on install) ... the bike to put the motor on after it comes out of the frame.

Using zip ties in the rear on moving lateral links is fine. Write your name ... Spare tire tie down ($50): http://rally.build/sparco-spare-wheel-tie ...

That might keep the wire somewhat out of view, and fairly clean looking. I've read that mounting a rear light low is not the best idea, but I feel like the ...

To change your rear sprocket you first need to securely put your motorcycle on a stand. (The reason I say securely is because one time I didn't strap the ...

Dec 20, 2020 ... ... mounting points on the bag were spaced for a Brooks saddle - I had to zip tie an intermediate short piece of CF tubing to the bag loops on ...

I will attach pictures once I get home and put the bike together. I ... The stays have been fit using 6mm zip ties which look as good as factory fit ...

... out of the way with wire/rope/zip-tie, remove caliper support bolt. 3. Remove axle nut, 2 final drive bolts just in front of axle nut - left side.

... zip-tie. Almost impossible to see. I used the stock horn wires (which had ... -- In the Bag - some users have literally put the air pump in the bag on the bike.

Fitting Your Bike · Fuel / Fuel Gauge · Starting and Choke Use ... Be sure to un-plug the rectifier, snip the zip tie on the lower right (not the wire!!!) & ...

... Motorcycle Protective Clothing 6006 - Apparel & Accessories > Clothing ... Ties 259 - Electronics > Electronics Accessories > Cables 1867 - Electronics ...

... bike plug into Kisan, run light sensor out of bucket to someplace you can zip-tie it to point to sky, reassemble bucket - done! Also can be programmed for ...